| |
|
| |
| Sterling
OSHA Conveyor Netting |
|
| |
|
| |
Sterling
carries a wide variety of conveyor netting. Listed in the
table below are some of our more popular conveyor net styles.
For your convenience, these images are shown actual scale.
Also, at the bottom of the page we have helpful Conveyor
Net Configuration diagrams and Typical
Conveyor Net Installation diagrams to assist you in development. |
| |
|
| |
|
| |
| |
Conveyor
Netting
SNT
63116
(Click
on Netting Picture for Full Scale Image)
Square
Mesh Size 3/16"
Load
Test Max 100 lbs.
Uses:
Ideal for collecting small light parts under conveyor,
inventory or shelf backing separation. Maximum pass-through
security
|
|
 |
|
|
| |
|
| |
| |
 |
|
Conveyor
Netting
SNT 63285
(Click
on Netting Picture for Full Scale Image)
Square
Mesh size - 3/4"
Load
Test Max 700 lbs.
Uses:
For small light weight fragile parts. Use under conveyor
for retention.
|
|
|
| |
|
| |
| |
Conveyor
Netting
SNT 63400
(Click
on Netting Picture for Full Scale Image)
Square
Mesh Size 1"
Load
Test Max 500 lbs.
Uses:
Sterling's most common net. Used for both Conveyor
and Rack Guard Netting. Designed for small products
or cartons, up to medium loads.
|
|
 |
|
|
| |
|
| |
| |
 |
|
Conveyor
Netting
SNT 63520
(Click
on Netting Picture for Full Scale Image)
Square
Mesh Size 1 7/8"
Load
Test Max 600 lbs.
Uses:
Used as both Rack Guard and Conveyor Netting. Designed
for medium loads. Larger mesh hole allows for light
to pass through.
|
|
|
| |
|
| |
| |
Conveyor
Netting
SNT 63590
(Click
on Netting Picture for Full Scale Image)
Square
Mesh Size 1 1/8"
Load
Test Max 900 lbs.
Uses:
Rugged fabric for Rack and Conveyor Netting. Medium
weight loads. Small mesh prevents snagging on moving
parts or boxes.
|
|
 |
|
|
| |
|
| |
| |
 |
Conveyor
Netting
SNT 63636
(Click
on Netting Picture for Full Scale Image)
Square
Mesh Size 1 3/4"
Load
Test Max 1,300 lbs.
Uses:
Strong cord netting, ideal where overhead protection
is needed. Medium to heavy loads.
|
|
|
| |
|
| |
| Conveyor
Net Configurations |
|
| |
 |
 |
 |
| Box
Shaped Guard |
Vertical
Side Guard |
"L"
Shaped Guard |
|
| |
 |
 |
| Cantenary
Curve Guard |
Horizontal
Side Guard |
|
| |
|
| |
| Typical
Conveyor Net Installation |
|
| |
A
typical Conveyor Net Installation usually consists of two
(or more - depending on the netting installation) parallel
cables running parallel with, and for the length of, the conveyor,
supporting the netting. Steel support rods are hung from the
ceiling approx. every 20', keeping a clean factory floor.
Note that this design changes only slightly with the different
configurations above. |
| |
 |
| |
|
| |
|
